download
1. Remove the headliner, for regular and supercab vehicles. Lower and position the headliner forward, for supercrew vehicles. For additional information, refer to interior trim and ornamentation . 2. Remove the rear trim panel pin-type retainers. 3. Remove the rear trim panel. 4. Remove the rear corner trim. For supercab vehicles, remove the b-pillar trim panel. For supercrew vehicles, remove the c-pillar trim panel. For additional information, refer to interior trim and ornamentation . Power sliding rear window 5. Remove the lh cable first, then the rh side cable. Press and hold the transition block away from the centerline of the vehicle. 6. Clamp and hold the cable near the transition block.

download
Rear door trim panel removal all vehicles 1. Remove the door pull handle cover by inserting and twisting a suitable tool into the hole provided. 2. Remove the screws. 3. Remove the door latch release handle bezel. 1. Remove the cover and screw. 2. Lift the bezel to release. 3. Remove the bezel. Vehicles with power windows 4. Remove the door latch release handle bezel. Vehicles with manual windows 5. Remove window regulator handle. All vehicles 6. Remove the trim panel screws. 7. Remove the trim panel. 1. Rotate the trim panel upwards. 2. Remove the trim panel. Installation 1. To install, reverse the removal procedure.

download
Some 1999-2003 f-150 vehicles may exhibit windnoise and/or a water leak from the back glass area. Action: to service, order and install service kit 3l3z-1542052-aa. Refer to the installation instructions included in the kit. It will also be necessary to obtain a tube of motorcraft instant adhesive (ta-19) or equivalent for this repair. Note: the kit applies to both manual and power sliding rear windows. Part number 3l3z-1542052-aa kit – back window seal ta-19 other applicable articles: none warranty status: eligible under provisions of new vehicle limited warranty coverage operation 040202a install backlight sliding seals (includes time to remove rear seat back on s/cabs vehicles or to loosen upper portion of back panel on regular cab and super crew vehicles part name instant adhesive

download
Removal and installation 1. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out. 2. Remove the 2 third row backrest-to-floor nuts. To install, tighten to 40 nm (30 lb-ft). 3. Remove the 2 third row backrest-to-floor outer bolts. To install, tighten to 10 nm (89 lb-in). 4. Fold the third row seat backrest down and remove the rear load floor panel. 5. Access the backrest to floor attachments. 1. Release the trim fabric hook and loop fasteners. 2. Remove the wheel jack storage cover. 6. Remove the jack assembly. 7. Remove the 2 outer load floor support panel bolts and the load floor support panel. 8. Remove the 2 third row backrest-to-floor outer bolts. To install, tighten to 10 nm (89 lb-in). 9. Remove the 2 third row backrest-to-floor inner bolts. To install, tighten to 40 nm (30 lb-ft). 10. Remove the third row backrest. 11. To install, reverse the removal procedure. Seat – exploded view, third row

download
Issue some 2005-2006 escape, escape hybrid and mariner vehicles may exhibit a slow fuel fill or frequent filling station pump shut-offs, when refueling. Action install a revised fuel tank filler pipe. The revised pipe has an improved radius to increase the fuel flow rate. Refer to workshop manual section 310-01a. Note this condition may still occur on some vehicles even after the revised fuel tank filler pipe has been installed. Some filling station pumps may deliver fuel at a rate greater than the dot specification, or may use nozzle designs that are overly sensitive and tend to shut off prematurely. This is normal.