Filed Under (Honda) by auhow on 25-03-2012
download
Power steering pump reassembly (cont’d) pump rotor installation 1. Coat the lip of the new oil seal with steering grease (honda p/n 08733 – b070e). 2. Install the new oil seal in the pump housing by hand, then install the pump seal spacer. Note: insert the oil seal with its grooved side fac- ing in. 3. Install the pump drive shaft assembly with the spe- cial tool. 4. Install the 38 mm circlip with its tapered side facing out. Attachment, 37 x 40 mm 07746-0010200 5. Coat the side plate grooves with the recommended power steering fluid, then position the 16.8 x 1.9 mm and 54 x 1.9 mm o-rings on the side plate. 6. Install the preload spring in the pump housing. 7. Set the 4.5 x 49.8 mm roller in the 4.5 mm hole in the pump housing. 8. Set the side plate over the roller and install it on the pump housing. 9. Set the 5 x 26.8 mm roller in the 5 mm hole in the side plate. 10. Assemble pump rotor to the drive shaft with the “°” mark on the rotor facing upward. 11. Set the 10 vanes in the grooves in the rotor. Note: be sure that the round ends of the vanes are in contact with the sliding surface of the cam ring.
